Low

AH1802-WG-7 - 

Hall Effect Sensor, Omnipolar, 1 mA, SC-59, 3 Pins, 2.5 V, 5.5 V

DIODES INC. AH1802-WG-7

Attēls ir tikai kā piemērs. Lūdzu, skatiet produkta aprakstu.

Ražotāja detaļas Nr.:
AH1802-WG-7
Pasūtījuma kods:
1825243RL
Tehnisko datu lapa:
(EN)
Skatiet visus tehniskos dokumentus

Informācija par produktiem

:
-40°C
:
1mA
:
SC-59
:
85°C
:
3Pins
:
-
:
-
:
Omnipolar
:
2.5V
:
Cut Tape
:
5.5V
:
-
Atrast līdzīgus produktus Izvēlieties un mainiet iepriekš redzamos atribūtus, lai atrastu līdzīgus izstrādājumus.

Produktu pārskats

The AH1802-WG-7 is an Ultra-sensitive Omnipolar Hall Effect Sensor Switch designed for portable and battery powered equipment such as cellular phones, PDA's and portable PC's. Based on two sensitive Hall Effect plates and chopper stabilized architecture the AH1802 provides a reliable solution over the whole operating range. To support portable and battery powered equipment the design has been optimized to operate over the supply range of 2.5 to 5.5V and consumes only 24µW with a supply of 3V. The single open drain output can switched on with either a North or South pole of sufficient strength. When the magnetic flux density (B) perpendicular the part marking surface is larger than operate point (Bop) the output is switched on (pulled low). The output is turned off when B becomes lower than the release point (Brp). The output will remain off when there is no magnetic field.
  • Omnipolar (North or South pole) operation
  • High sensitivity
  • Single open drain output
  • Micropower operation
  • Superior temperature stability
  • Minimal switch point drift
  • Enhanced immunity to stress
  • Good RF noise immunity

Lietošanas veidi

Portable Devices, Communications & Networking, Computers & Computer Peripherals, Multimedia, Consumer Electronics

Brīdinājumi

ESD sensitive device, take proper precaution while handling the device.

Saistītie produkti

Salīdzināt atlasīto