Low

IS43TR16640A-15GBLI - 

SDRAM, DDR3, 64M x 16bit, 12 ns, FBGA-96

INTEGRATED SILICON SOLUTION (ISSI) IS43TR16640A-15GBLI

Attēls ir tikai kā piemērs. Lūdzu, skatiet produkta aprakstu.

Ražotāja detaļas Nr.:
IS43TR16640A-15GBLI
Pasūtījuma kods:
2409131
Tehnisko datu lapa:
(EN)
Skatiet visus tehniskos dokumentus

Informācija par produktiem

:
-40°C
:
95°C
:
12ns
:
64M x 16bit
:
96Pins
:
-
:
FBGA
:
-
:
Cut Tape
:
16Kbit
:
MSL 3 - 168 hours
Atrast līdzīgus produktus Izvēlieties un mainiet iepriekš redzamos atribūtus, lai atrastu līdzīgus izstrādājumus.

Produktu pārskats

The IS43TR16640A-15GBLI is a 1Gb DDR3 SDRAM supports 1333MT/s data rate. It has high speed data transfer rates with system frequency up to 933MHz, 8 internal banks for concurrent operation and 8-bit pre-fetch architecture. CK and CK# are differential clock inputs. All address and control input signals are sampled on the crossing of the positive edge of CK and negative edge of CK#. CKE HIGH activates and CKE Low deactivates, internal clock signals and device input buffers and output drivers. All commands are masked when CS# is registered HIGH. CS# provides for external Rank selection on systems with multiple Ranks. CS# is considered part of the command code. On Die Termination: ODT (registered HIGH) enables termination resistance internal to the DDR3 SDRAM. When enabled, ODT is only applied to each DQ, DQSU, DQSU#, DQSL, DQSL#, DMU and DML signal. The ODT pin will be ignored if MR1 and MR2 are programmed to disable RTT.
  • VDD and VDDQ = 1.5V ±0.075V Standard Voltage
  • VDD and VDDQ = 1.35V + 0.1V, -0.067V Low voltage (L)
  • 5, 6, 7, 8, 9, 10 and 11 Programmable CAS latency
  • 0, CL-1, CL-2 Programmable additive latency
  • Programmable CAS WRITE latency (CWL) based on tCK
  • 4 and 8 programmable burst length
  • Sequential or interleave programmable burst sequence
  • BL switch on the fly
  • Auto Self Refresh (ASR)
  • Self refresh temperature (SRT)
  • Partial array self refresh
  • Asynchronous RESET pin
  • TDQS (termination data strobe) supported (x8 only)
  • OCD (Off-Chip Driver impedance adjustment)
  • Dynamic ODT (On-Die Termination)
  • Driver strength - RZQ/7, RZQ/6 (RZQ = 240R)
  • Write levelling

Lietošanas veidi

Industrial, Commercial, Automotive